Home

Your PAINT USAGE MONITORING KIT

includes the following:

  • Raspberry Pi© computer (pre-programmed)
  • Power Supply for the Pi
  • Airline monitoring switch
  • 1/2 inch Shark-Bite© fittings
  • plug & socket to extend the airline wiring (if needed)


 

INSTALLATION

  1. Choose a suitable place to locate the Raspberry Pi (near your internet connection).
  2. Disassemble the airline to the booth to create space for the sensor tube. (!MUST be after an airline filter!). Attach the supplied Shark Bite fittings. Push the sensor tube into the Shark Bites with the arrow on the sensor pointing down (air inlet-wires come out bottom of sensor). !The sensor MUST be vertical! Made a mistake, use the supplied orange release tool to remove the sensor tube.
  3. Plug the airline sensor into the Pi.
  4. Plug in the internet connection.
  5. Plug in the power adapter and wait for the system to boot up.
  6. Pull the trigger on the spray gun then go to our monitoring site (http://66.45.229.198/login or thru the envirobase.ca site) log in with your credentials and check that the trigger duration is logged.

If you need to extend the wiring to the airline flow sensor, use the supplied 3.5 mm socket and plug. Regular bell wire or any suitable double wire will work well.

Kit Costs & ORDER YOUR KIT HERE

Joomla SEF URLs by Artio
Cron Job Starts